1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

traffic monitoring

Discussion in 'General Cisco Certifications' started by Cunningfox, Dec 16, 2011.

  1. Cunningfox

    Cunningfox Byte Poster

    219
    6
    27
    Hi,

    Just been thinking to myself about improving our traffic monitoring and wondered if it was possible to monitor traffic flows on a 3560 switch at either L3 or L2?

    I immediately thought about netflow or nbar but these aren't supported, are there any other options?
     
    Certifications: CCNP, CCNA, MCP
    WIP: ??
  2. Cunningfox

    Cunningfox Byte Poster

    219
    6
    27
    That's a resounding no idea then... hmmm needs more thought.
     
    Certifications: CCNP, CCNA, MCP
    WIP: ??
  3. keconnect sparky

    keconnect sparky Nibble Poster

    78
    5
    34
    Only monitoring your'll be able to do is SNMP ... not as granular as netflow/nbar, but you dont have them options :(
     
    Certifications: MCP, CCENT, CCNA, CCNA-S
    WIP: CCNP (ROUTE)
  4. cisco lab rat

    cisco lab rat Megabyte Poster

    660
    62
    116
    Certifications: Yes I pretty much am!!
    WIP: Fizzicks Degree
  5. Cunningfox

    Cunningfox Byte Poster

    219
    6
    27
    Cheers, I've got SNMP software but a freebie is always worth a check :).

    Any idea what the bottom end switch that supports netflow is? I read somewhere that 3750's do but I can't find anything to back that up on the feature navigator and don't have one to check manually myself.
     
    Certifications: CCNP, CCNA, MCP
    WIP: ??

Share This Page

Loading...