1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Cannot hot sync

Discussion in 'New Members Introduction' started by Joea, Jun 5, 2005.

  1. Joea

    Joea New Member

    1
    0
    1
    Wheneven I try to hotsync i receive the following message. This feature is not available when the port is in use.
    How cab i fix?
     
  2. Mitzs
    Honorary Member

    Mitzs Ducktape Goddess

    3,282
    73
    152
    Hi Joea, and welcome to cf.

    I"m not sure what your trying to do but you might want to post your question on this board instead. You might get a faster reply.

    http://www.certforums.co.uk/forums/f18-problems,-suggestions-&-comments.html
     
    Certifications: Microcomputers and network specialist.
    WIP: Adobe DW, PS
  3. JonnyMX

    JonnyMX Petabyte Poster

    5,239
    211
    236
    Hi and welcome.
    I was a bit confused by your question too.
    Say hi and introduce yourself, then get stuck in with the tech stuff...
     
    Certifications: MCT, MCTS, i-Net+, CIW CI, Prince2, MSP, MCSD
  4. tripwire45
    Honorary Member

    tripwire45 Zettabyte Poster

    13,493
    179
    287
    Greetings, Joea and welcome to CertForums. I have to agree with the others. I believe your question is a tad too vague. Maybe if you could give us a few more details about what you are trying to do. Hope we can help.
     
    Certifications: A+ and Network+

Share This Page

Loading...