1841 with 2shdsl card using BT SDSL

Discussion in 'Networks' started by Swazi Gold, Aug 14, 2009.

  1. Swazi Gold

    Swazi Gold New Member

    1
    0
    1
    I am trying to connect my Cisco 1841 with a 2shdsl card to my existing BT SDSL service.

    I can see the controller come up, the ATM interface come up, but DSL on the group is up and down.

    When I use my old 878 with the built in G.SHDSL card it works fine.

    IOSon router is c1841-adventerprisek9-mz.124-11.XJ4.bin
    We are using a standard RJ11 cable supplied by cisco
    SHDSL is in CPE mode.


    Anyone out there been able to get thsi to work?

    My current config is as follows:

    controller SHDSL 0/0/0
    dsl-group 0 pairs 0
    shdsl annex B
    shdsl rate auto

    interface atm 0/0/0
    no ip address
    ip virtual-reassembly
    atm ilmi-keepalive
    pvc 0/38
    encapsulation aal5mux ppp dialer
    dialer pool-member 1
     

Share This Page

Loading...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.