Cisco 877 and watchguard X700

Oh man! Ad-blocking software has been detected! :'(

This website is run by the community, for the community... and it needs advertisements in order to keep running. Blocking our ads means your killing our stats!
Please disable your ad-block, or become a premium member to hide all advertisements and this notice.

Hello,

I've got a bit of a problem in that 'm trying to make a Watchguard X700 connect through the internet via cisco 877 DSL router with a dynamic ip address. What I want to test is to access the internet via the router in bridge mode. I'm not sure on how to do this although I've setup the internet connection and interface 0. There is a default Vlan setup as well. The router is going to be a backup firewall in case the watchguard has a hardware failure. How would I configure via the command line to forward all traffic to the watchguard port?

Thanks

Sajj

 

Oh man! Ad-blocking software has been detected! :'(

This website is run by the community, for the community... and it needs advertisements in order to keep running. Blocking our ads means your killing our stats!
Please disable your ad-block, or become a premium member to hide all advertisements and this notice.

If you could post some more information it would help. How are the devices connected? What sort of redundancy do you hope to accomplish?

Spice_Weasel