Wireless QOTD for May 24th

Discussion in 'Wireless' started by tripwire45, May 24, 2004.

  1. tripwire45
    Honorary Member

    tripwire45 Zettabyte Poster

    13,493
    180
    287
    When choosing an RF amplifier to adjust the signal between your transmitter and outdoor antenna, you should already know the specifications required in this section of your WLAN construction. Of the choices below, which ones are amplifier specifications? Choose all that apply.

    A. Impedance (ohms)
    B. Gain (dB)
    C. Frequency response
    D. Input
    E. Output

    Answer later.
     
    Certifications: A+ and Network+
  2. Jakamoko
    Honorary Member

    Jakamoko On the move again ...

    9,924
    74
    229
    B and E for me.
     
    Certifications: MCP, A+, Network+
    WIP: Clarity
  3. tripwire45
    Honorary Member

    tripwire45 Zettabyte Poster

    13,493
    180
    287
    Man, I didn't think this one was that tough. I scared everyone except Gav away.
     
    Certifications: A+ and Network+
  4. flex22

    flex22 Gigabyte Poster

    1,679
    0
    69
    It is without doubt B and E, I think, maybe, yeah it's them.
    Anyway Jak said those so they must be right :iagree
    ....., maybe :daz

    Answers: A, B.
     
  5. tripwire45
    Honorary Member

    tripwire45 Zettabyte Poster

    13,493
    180
    287
    Correct answer time: ABCDE. Sorry gang. They are all specifications for RF amplifiers. Well, that's one. Four more to go in the week. See you tomorrow.
     
    Certifications: A+ and Network+
  6. flex22

    flex22 Gigabyte Poster

    1,679
    0
    69
    Dammit :!:
    For a second their I almost put all fo them.Honest :!:
     

Share This Page

Loading...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.