1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Quick question

Discussion in 'Routing & Switching' started by Headache, Jan 17, 2007.

  1. Headache

    Headache Gigabyte Poster

    1,092
    9
    85
    Hi,

    Does anyone know how I can get rid of this sub-interface ?

    It's definitely outlived it's welcome, but I can't get it to leave.

    1#conf t
    Enter configuration commands, one per line. End with CNTL/Z.
    R1(config)#int serial 0/0.1
    R1(config-subif)#no interface serial 0/0.1
    % Not all config may be removed and may reappear after reactivating the sub-interface
    R1(config)#int serial 0/0
    R1(config-if)#no interface serial 0/0.1 multipoint
    % Not all config may be removed and may reappear after reactivating the sub-interface
    R1(config)#^Z

    R1#sh ip int brief
    Interface IP-Address OK? Method Status Protocol
    FastEthernet0/0 192.168.1.2 YES NVRAM up down
    Serial0/0 unassigned YES manual up down
    Serial0/0.1 unassigned YES NVRAM deleted down
    Serial0/1 unassigned YES manual administratively down down
    FastEthernet1/0 unassigned YES manual administratively down down
    R1#
     
    Certifications: CCNA
    WIP: CCNP
  2. Headache

    Headache Gigabyte Poster

    1,092
    9
    85
    Nevermind.

    I just saved up and rebooted and that took care of it.

    Sorry for wasting the bandwidth.
     
    Certifications: CCNA
    WIP: CCNP

Share This Page

Loading...