need CCNA Voice-simple LAB setup

Oh man! Ad-blocking software has been detected! :'(

This website is run by the community, for the community... and it needs advertisements in order to keep running. Blocking our ads means your killing our stats!
Please disable your ad-block, or become a premium member to hide all advertisements and this notice.

hello guys...i want to take CCNA Voice...and i already read the CCNA Voice (ecomm guide) but dont know where to start the lab...
but here's the equipment in my arsenal...

1 2811 Router (with 4 FXS module)...standard IOS (cisco IOS advent...)
1 3650 PoE switch
2 IP Phone 7940 (factory default)

the topology i want to make is simple...one phone can ring to another phone...

Router fa0/0 --> Switch fa0/1
Switch fa0/2 & fa0/3 --> to IP Phone

what should i configure in the router and switch or even in the phone ?? can you help me ??

sory for create another post...(too many...i didn't have enough time to read them all)

 

Oh man! Ad-blocking software has been detected! :'(

This website is run by the community, for the community... and it needs advertisements in order to keep running. Blocking our ads means your killing our stats!
Please disable your ad-block, or become a premium member to hide all advertisements and this notice.

Did you find the info you needed?

 

no, until now...i can't find a proper configuration...
i just want to straight to the CLI...not knowing anything with CUCME

 

Hey Rahman, I'm in the same situation as you. Is there a virtual lab available for replicating a simple voice network i.e. two phones?