1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Mouse not working with KVM :o

Discussion in 'Hardware' started by Ence, Jun 3, 2009.

  1. Ence

    Ence Kilobyte Poster

    338
    8
    30
    Have to replace Nikkai A36GN mouse swaped like for like. Old did work on each channel KVM
    Now the new one doesn't work ! On any channel but does work if plug straight into computer.

    I have uninstalled drivers from Device manager rebooted then as I plug mouse back in it load drivers again.

    This mouse is same make & model as old one.
    also have tried an other mouse just to make sure KVM is work OK. And is working

    Can't get a mouse to work a bit :oops:

    what you think CF

    edit:

    Have changed KVM channels cable still not working with new mouse
    Have tried old mouse and is working on all channels

    can't see why new mouse doesn't like KVM as above it the same make & model
     
  2. greenbrucelee
    Highly Decorated Member Award

    greenbrucelee Zettabyte Poster

    14,283
    254
    329
    this could be long shot but it could be that the mouse port is damaged.
     
    Certifications: A+, N+, MCDST, Security+, 70-270
    WIP: 70-620 or 70-680?
  3. UKDarkstar
    Honorary Member

    UKDarkstar Terabyte Poster

    3,477
    121
    184
    I know I used to get probs with kvm's and radio kb/mouse combo's - would work fine and then just stop.
     
    Certifications: BA (Hons), MBCS, CITP, MInstLM, ITIL v3 Fdn, PTLLS, CELTA
    WIP: CMALT (about to submit), DTLLS (on hold until 2012)

Share This Page

Loading...