It goes ro show, what some scraped of skin and a bit of blood can produce

Oh man! Ad-blocking software has been detected! :'(

This website is run by the community, for the community... and it needs advertisements in order to keep running. Blocking our ads means your killing our stats!
Please disable your ad-block, or become a premium member to hide all advertisements and this notice.

I realised one of the thumb screws wasn't in as tightly as it shoud be, so I thought I shoud tighten it next I found out that the bracket scapes the copper of the north bridge if I make it tighten any further.

I have been getting stable 3.52GHz when overclocking, I decided to tighten the northbridge end as tight as possible even though there was a bit of scraoing going on.

I am now running at 440MHz x 9 on the FSB which is 4.1 GHz almost

And I might add this PC is kicking butt

 

Oh man! Ad-blocking software has been detected! :'(

This website is run by the community, for the community... and it needs advertisements in order to keep running. Blocking our ads means your killing our stats!
Please disable your ad-block, or become a premium member to hide all advertisements and this notice.

I mean 445 for the FSB.

 

Then you can take it to another level and go with water cooling. Who knows what speeds you can accomplish with that

 

I have thought about it since my mobo has a built in water block ready for it.

 

I'll keep my speed to my motor with it's 4l engine

 

Be careful of china syndrome! it might burn a hole through your floor and disappear

 

I've knocked it dows to 433 because at 445 my ram was being pushed past it's frequency by 1 vut 4GHz will do nicely.

OCCT has produced a stable reading, I gt 59 degrees at full load but am gonna put an extra fan in later today.