HSRP configuration

Discussion in 'General Cisco Certifications' started by insurin, May 19, 2009.

  1. insurin

    insurin Bit Poster

    23
    0
    2
    The scenario

    4 X 6500 running CatOS plus 4 MSFC modules
    2 6500's at each site.
    100MB Fibre connection between the sites. This is a layer 2 connection.

    The current setup is configured using HSRP. Router B is the active router for vlan 1 at the moment. All 4 6500s use the standby address of 192.168.1.1 and are in the same group.
    There are 10 additional vlans on each site. vlan 2-11 on site 1 and vlan 12-21 on site 2.
    All services such as Mail/file are on site 1.

    What would be the most optimal setup for HSRP.

    Or should I be looking at adding a connection from the fibre link to the cores at each site that are currently not directly connected to the link (Router A & D)
     

    Attached Files:

Share This Page

Loading...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.