1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

How to restore a Cat2950 to Factory without Line password?

Discussion in 'Routing & Switching' started by BraderzTheDog, May 8, 2012.

  1. BraderzTheDog

    BraderzTheDog Kilobyte Poster

    276
    2
    49
    Howdy,

    I've picked up a switch from ebay (damit I went wrong on the first line!) and the config has not been erased... Not that im bothered but they locked down the CONSOLE PORT! Damit.

    Logon banner states something about DHL... Which is quite surprising since it was delivered by DPD :)

    How can I erase the config without gaining access to privilege mode? Am I doing something stupid?
     
    Certifications: CCNA R&S, CCNA-SEC, CCSA, JNCIA FWV, MCITP, MCTS, MTA, A+
  2. pete.grant

    pete.grant Byte Poster

    150
    9
    37
    Cisco Catalyst Fixed Configuration Layer 2 and Layer 3 Switches - Cisco Systems
     
    Certifications: A+ IT Technician, CCENT, CEH, CPTS, CIW Security Analyst, ITIL v3 Foundation, Master CIW Administrator, MCITP (Windows Server 2008:SA), MCSA on Windows Server 2008, MCSA:Security on Windows Server 2003, MCTS (70-648, 70-652), Network+, SCNS, Security+, Server+
  3. BraderzTheDog

    BraderzTheDog Kilobyte Poster

    276
    2
    49
    Sorted, thank you very much Pete! :D
     
    Certifications: CCNA R&S, CCNA-SEC, CCSA, JNCIA FWV, MCITP, MCTS, MTA, A+

Share This Page

Loading...