1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Hey, i need help on this simple topology

Discussion in 'General Cisco Certifications' started by kobem, Mar 5, 2011.

  1. kobem

    kobem Megabyte Poster

    Here is the topology from Packet Tracer application


    The problem is that i can not ping Comp5 and Comp6 from Comp4 and Comp3
    or from remote network which Comp1 and Comp2 reside.

    I can reach from Comp1 and Comp2 to Comp3 and Comp4
    I can reach from Comp3 to Comp4 and opposite side.
    I can reach Comp3 and Comp4 to Comp1 and Comp2

    However, no connectivity to and from Comp5 and Comp6 under on the rightest switch of the topology. Can't find why. Please help me!
    Certifications: CCNA
  2. gosh1976

    gosh1976 Kilobyte Poster

    A few questions for you.

    Did you design that topology and do the configs yourself?

    Are you just using the simple pdu to ping or are you actually going into a command prompt on the pc and pinging from there? Are you watching in simulation mode to see where the packets drop? If you are using the simple pdu are you pressing the little red button so they run more than once?
    Certifications: A+, Net+, MCDST, CCENT, MCTS: Win 7 Configuring, CCNA
  3. TheITCrowd

    TheITCrowd Kilobyte Poster

    I assume you have fixed it, because it's all pingable?
    Certifications: Network + |CCNA |MCTS-70-680,MCTS-70-401, MCTS-70-656, MCTS-70-351 |HP AIS ProCurve Networking -2011 | HP2-896 |VCD-CP27|JNCIA |Hewlett Packard ASE - Network Infrastructure (2011)
    WIP: 642-813
  4. kobem

    kobem Megabyte Poster

    No, i have tried many times again. But still was unable to find the issue. for a long time, i have been
    running Packet Tracer 5.1. As far as i see, packets drop while they are coming back from the r2 and going
    through sw1 but are killed that time without visiting sw 2.
    Certifications: CCNA

Share This Page