1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Cisco tracer packet

Discussion in 'General Cisco Certifications' started by Nicat T Mirzeyev, Jan 27, 2013.

  1. Nicat T Mirzeyev

    Nicat T Mirzeyev Bit Poster

    10
    0
    4
    Hi gent,


    i am not able to use some commands on tracer packet . i dont know how to enable it. i use 5.3.2 version

    here u are some examples:


    SW1(config)#ip domain-name cisco.com
    ^
    % Invalid input detected at '^' marker.


    SW1(config)#crypto key generate rsa 1024
    ^
    % Invalid input detected at '^' marker.



    can somebody explain what is problem actually??


    i cant use command 'alias' too
     
  2. Coupe2T

    Coupe2T Megabyte Poster

    590
    43
    67
    Packet tracer is essentially only an emulator of relevant hardware, so you will find that not every single Cisco command will work, and you may also find that some commands only work with certain hardware etc.

    If you want to guarantee all commands work then you would be better off getting real hardware to work with in a lab.
     
    Certifications: ECDL, Does that Count!?!

Share This Page

Loading...